Perform Pixel Mapping - Ricoh WG-20 Operating Manual

Perform Pixel Mapping

Pixel mapping is a function for mapping out and correcting for defective
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
• Pixel Mapping is only available in A mode. Pixel mapping cannot
be selected even if the [W Setting] menu is displayed by pressing
the 3 button in Q mode.
• When executing Pixel Mapping from Q mode, press the Q button
once to enter A mode. Then press the 3 button and the four-
way controller (5) to display the [W Setting] menu and select Pixel
Mapping.
• Pixel Mapping cannot be selected in Voice Recording mode.
1
Press the 3 button in A mode, and then press
the four-way controller (5) once.
The [W Setting] menu appears.
2
Use the four-way controller (23) to select [Pixel Mapping].
3
Press the four-way controller (5).
The [Pixel Mapping] screen appears.
4
Use the four-way controller (2)
to select [Pixel Mapping].
5
Press the 4 button.
Defective pixels are mapped and corrected.
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] is displayed on the monitor. Use the AC adapter
kit K-AC117 (optional) or use a battery with ample capacity remaining.
Pixel Mapping
Checks the image sensor
and corrects defective
pixels
Pixel Mapping
Cancel
7
OK OK
237