Ricoh WG-20 Operating Manual page 122

6
Press the 3 button.
The camera returns to capture mode.
Refer to the following "Manual Setting" for instructions on adjusting
the white balance manually.
If you change the [White Balance] setting frequently, you can save time
by assigning the Fn settings to the Green button (p.130).
Saving the White Balance setting 1p.149
3
Manual Setting
Have a blank sheet of white paper or similar material ready.
1
In the [White Balance] screen, use the four-way controller
(23) to select K (Manual).
2
Point the camera at the blank
sheet of paper or other material
so that it fills the frame displayed
in the center of the screen.
3
Press the shutter release button fully.
The white balance is automatically adjusted.
4
Press the 4 button.
The setting is saved and the screen returns to the [A Rec. Mode]
menu.
5
Press the 3 button.
The camera returns to capture mode.
120
White Balance
Adjust Adjust Adjust Adjust
SHUTTER SHUTTER SHUTTER
MENU MENU MENU Cancel Cancel Cancel OK OK OK OK OK OK