Perform Pixel Mapping - Ricoh WG-5 GPS Operating Manual

Perform Pixel Mapping

Pixel Mapping is the function for mapping out and correcting defective pixels in
the image sensor. Run the Pixel Mapping function if image dots always seem to
be defective in the same place.
• Pixel Mapping is only accessible from A mode. Pixel Mapping cannot be
selected even if the [W Setting] menu is displayed by pressing the 3
button in Q mode.
• When executing Pixel Mapping from Q mode, press the Q button once
to enter A mode. Then press the 3 button and the four-way controller
(5) to display the [W Setting] menu and select Pixel Mapping.
1
Use the four-way controller (23) to select [Pixel Mapping] in
the [W Setting] menu.
2
Press the four-way controller (5).
The [Pixel Mapping] screen appears.
3
Use the four-way controller (2) to
select [Pixel Mapping].
6
4
Press the 4 button.
Defective pixels are mapped out and corrected.
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] appears on the display. Use the AC adapter kit K-
AC117 (optional) or use a battery with ample capacity remaining.
184
Pixel Mapping
Checks the image sensor
and corrects defective
pixels
Pixel Mapping
Cancel
OK
OK