Remote Keypads - Texecom Premier 48 Installation Manual

Installation

Remote Keypads

Keypad Layout
Tamper
Speaker
Switch
Output
Address
Switch
Connecting Keypads
Keypads are connected to the network terminals located at
the bottom left hand corner of the control panel (see pages
12 & 13 for details).
Keypad Addressing
Each keypad must be assigned a different address using the
DIL switches located on the left hand side of the PCB. The
table below shows the keypad addressing:
Address DIL 1 DIL 2
1 On or off
2 Off
3 Off
4 Off
5 * On
6 * Off
7 * Off
8 * On
Engineers On
* Premier 88, 168 and 640 only
Never set two keypads on the same network to the
same address.
When using a keypad as an Engineer's keypad, the
DIL switches must all be 'On'.
Keypad Zones
The keypad has two programmable zones (see page 19 for
details). Each zone is also fully programmable (see page 35
for details).
14
Output
Network
Terminals
NE TWORK
DIL 3 DIL 4
Off Off Off
On Off Off
Off On Off
Off Off On
Off Off On
On Off On
Off On On
Off On On
On On On
Zone Numbering
The table below shows the zone allocation when the keypads
are installed:
Address
1
2
3
4
Piezo
Sounder
5 *
6 *
Zones
7 *
8 *
* Premier 88, 168 and 640 only
The zones inside the keypads are not seen by the
system until they have been mapped to a zone number
(see page 57 for details).
For Premier 640 see page 18 for details
Keypad Output
The remote keypad has one programmable output, which
can be used to drive auxiliary devices such as LED's,
sounders or relays etc. Wire as per Panel Outputs shown on
page 21
characteristics for the output are shown below:
Output
1 2 3 4
1
1 2 3 4
1 2 3 4
Keypad Speaker Output (LCDL/LCDLP Only)
1 2 3 4
The Premier LCDL and Premier LCDLP keypads have an
1 2 3 4
output that can be used for driving up to one 16Ω or two 8Ω
1 2 3 4
loudspeakers (see page 20 for details).
1 2 3 4
The speaker volume is also fully adjustable (see page
1 2 3 4
57 for details).
1 2 3 4
Programmable 'Info.' LED
The 'Info.' LED on the front of the keypad can be
programmed to mimic the keypad output or show the armed
status of an area (see page 57 for details).
Adjustable Backlighting
To adjust the keypad backlighting press the YES key for 5
seconds, then with the YES key still pressed use
increase or decrease the backlighting until the required
brightness is achieved, then release both keys.
The backlight can only be adjusted when the keypad is
not in a menu.
Keypad Lid Tamper
The lid tamper of each keypad can be disabled if required
using the relevant keypad option in the Keypad Setup menu
(see page 57 for details).
Premier 48, 88, 168 & 640 Installation Manual
Zones
(Network 1)
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
(see page 60 for details).
Max Current
100mA
Zones
(Network 2)
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
Unmapped
The electrical
Type
Switched -ve
to
INS176