Pitney Bowes DM100i Series Service Manual & Parts List page 46

4 • Troubleshooting
Table 4-11 Motion control Processor (McP) Related error codes (16xx codes)
Error Description
1600 No Error
1601-1627 Reserved
1628 Failed to Feed
1629 Printer Not Ready
162A TAR2 Exit Jam
162B Printer Error
162C Transport Jam
162D TAR1 Exit Jam
162E Tape Jam
162F Printer Over run
1630 Trip Jam
1631 Mail piece too thick (jam)
1632 Print Head Fire Timeout
1633 Printer Not Ready during Tape
1634 Printer Error during Tape Printing
1635 A 'Run "ail" operation was attempted with mail in the transport area.
1636 The Power Stacker is Full
1637 Skewed mail piece (reported by DM400 only)
1638 Mailpiece Hold Error (Differential Weighing)
1639 CSpark Tape Stream Error
163A Jam at hand-off to the WOW Module
163B Mail Piece too long - happens if the WOW sensor signifying that the piece is in position to weigh is
blocked and the WOW entry sensor is still blocked
163C WOW Done message not received by MMC in specified time (WOW Weighing timeout) - a 5 second
timeout on the handshake with the weighing module.
163D WOW Re-Zero Error
163E WOW Weight Error
163F-1658 Reserved
1659 Non-volatile Memory Failure
165A Invalid Parameter Checksum in NVM
165B Invalid Cycle Count Checksum in NVM
165C Invalid Jam Count Checksum in NVM
165D MCP Reset due to Watchdog Timeout
165E Bad Profile Command
4-16
SDT345A DM100i/DM200i Service Manual & Parts List