Threading The Gimp - Brother RH-9820 Instruction Manual

4. PREPARATION BEFORE SEWING

4-4. Threading the gimp

When threading the gimp, first remove the work clamp plates, and then thread the gimp correctly as shown in the illustration
below. Once threading has been completed, install the work clamp plates. (Refer to "3-19. Installing and removing the work
clamp plates".)
* The illustration below shows the method when the cotton stand is installed on the left side. If the cotton stand is installed on
the right side, the threading method will be different. Before threading, refer to "4-5. Threading the threads when the cotton
stand is installed on the right side".
- in the illustration show the positions for inserting the threader. (Refer to "4-2. Threading the upper thread" for
*
details on using the threader.)
<-00 specifications>
<-01 specifications>
<-02 specifications>
33
Gimp should
not be clamped
Gimp should be clamped
(when using about
#8 spun thread or
finer as the gimp)
Gimp should be
clamped
RH-9820
Gimp should
not be clamped
(when using a
thicker gimp)
0402B