Brother RH-9820 Instruction Manual page 75

5
Turn the upper shaft pulley by hand.
0435B
6
[If you would like to pause manual sewing and return the feed base to the material setting position]
Press the STOP switch (8) and then press the RESET key.
[Once sewing continues to the final stitch and the buzzer sounds]
When the needle bar is at the needle up stop position, press the start switch (7).
(Keep pressing until the feed base
returns to the material setting position.)
0532B
7. USING THE SEWING MACHINE (OPERATION PANEL: ADVENCED OPERATION)
•
The feed base will move to the next sewing start position in accordance
with the rotation of the upper shaft.
•
The number of remaining stitches (5) in the display will decrease by 1
each time the upper shaft pulley is rotated half a turn (when the needle
bar moves up and down once).
NOTE:
If the upper shaft pulley is turned in the reverse direction, no seam will be
formed, so do not turn it in the reverse direction.
(7)
Thread trimming will be carried out and the feed base will return to the
material setting position.)
NOTE:
If cutting operation is set to "Cutting after sewing", the hammer will operate.
RH-9820
(5)
0226B
0533B
0227B
0326B
66