Installing The Control Box - Brother RH-9820 Instruction Manual

3. INSTALLATION

3-2. Installing the control box

Before installing the control box, take steps to make sure that the control box does not fall down.
If this is not done, injury to feet or damage to the control box may result.
10mm or more
Leg
Operator
7
CAUTION
Operator
0340B
0404B
0341B
RH-9820
Before installing the control box (1),
check that the model plate (2) on the
control box (1) is "RX9820" to indicate
that it is an RX-control box for RH-9820
sewing machines.
(1) Control box
(3) Bolts [4 pcs.]
(4) Plain washers [4 pcs.]
(5) Nuts [8 pcs.]
NOTE:
Check that the control box (1) is at
least 10 mm away from the leg. If
the control box (1) and the leg are
too close together, it may result in
incorrect sewing
operation.
(6) Power switch
(7) Screws [2 pcs.]
(8) Staples [5 pcs.]
* Use the remaining two staples to
secure the power cord (9) in a
position that matches the position
of the wall outlet.
NOTE:
Take care when tapping in the
staples (8) to make sure that they
do not pierce the power cord (9).
machine