Starting The Sewing Machine - Brother RH-9820 Instruction Manual

5-2. Starting the sewing machine

1
Push the power switch (1) to the ON side.
2
Press the start switch (7).
<For 2-pedal foot switch
specifications>
<For treadle specifications>
Depress the treadle.
*1: If settings for an optional device have been made, the icon for the optional device will appear here.
Indexer Cut length changeover device Upper thread nipper device Upper thread breakage detector Air pressure detector
*2: The "standby condition" is the name for the period from the point after switching to one of these modes
until the first operation occurs.
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
<For 2-pedal foot switch/hand start switch specifications>
NOTE:
If "E110" is displayed, turn the upper shaft pulley (4)
by hand to align the index mark (5) on the pulley with
the notch (6).
<For hand start switch
specifications>
[The display examples are for a -01 specification sewing machine.]
The power indicator (2) will illuminate and the contents of the panel
display (3) will switch in the order shown below.
*1
The feed base will move to the material setting position.
The panel display will switch to the standby condition *
mode, manual mode, test mode, cycle program mode or program mode) that
was active when the sewing machine was last turned off.
RH-9820
Displayed for approx. 2 seconds
<For treadle specifications>
[During test mode]
2
for the mode (automatic
0407B
0261B
0314B
0311B
0312B
0313B
0408B
0409B
0506B
0507B
0229B
0264B 0267B
1644B
38