Threading The Gimp; Setting The Material - Brother RH-9800 Instruction Manual

5. CORRECT USE

5-7. Threading the gimp

Remove the cloth presser plates (refer to page 13), and then thread the gimp as shown in the illustration below.
Once threading is complete, replace the cloth presser plates.
<-00, -01>
0884Q
<-02>
Pass the gimp through the hole of
the thread tension stud (1).
0886Q

5-8. Setting the material

(1)
(2)
0889Q
1. Insert the material so that it touches the right and left cloth guides (1).
2. The sewing margin can be adjusted to within 10 - 30 mm.
3. Loosen the screws (2) at left and right and move the cloth guides (1) back and forth to adjust the sewing margin.
18
(1)
Refer to "9-17. Adjusting the gimp length after trimming (-02)" (Page 54).
(1)
(2)
RH-9800
(1)
10 - 30 mm
(2)
0885Q
(2)
0890Q