Table of Contents
Advertisement
Upper Threading
Upper Threading
CAUTION
When threading the upper thread, carefully follow the
instructions. If the upper threading is not correct, the
thread may become tangled or the needle may break and
cause injury.
Check the information displayed in the app, and thread the
machine with the required upper thread.
1
Press
(Threading position button) to set the
needle position to threading ready.
If the needle is not in the threading ready position, the
needle threader cannot thread the needle.
Depending on the needle position before pressing the
button, the needle is lowered once and then raised.
If the needle is already in a threading ready position, the
needle will not move even if the button is pressed.
2
Hold down
(Accept button).
Needle/thread change mode is entered. (page 21)
CAUTION
When threading the needle, be sure to lock all buttons,
otherwise injuries may occur if the "Start/Stop" button or
any other button is pressed and the machine starts.
3
Raise the spool pin and place the spool of thread
onto the spool pin.
Make sure that the thread unwinds as shown.
24
4
Slide the spool cap onto the spool pin.
Slide the spool cap as far as possible to the rear, as
shown, with the rounded side out.
CAUTION
Choose a spool cap that best fits the size of spool being
used. For more information regarding the choice of spool
caps for your thread choice, refer to "IMPORTANT" in step
3 of "Winding the bobbin" on page 18.
If the spool or the spool cap is not positioned correctly, the
thread may become tangled around the spool pin or the
needle may break and cause injury.
5
Pass the thread under the thread guide.
6
Pass the thread through the thread channel in the
order shown below.
4
1
4
2
5
3
Advertisement
Table of Contents
