Cleaning And Inspection As Required; Draining Lubricating Oil; Cleaning The Eye Guard; Lubrication - Brother RH-9820 Instruction Manual

8-3. Cleaning and inspection as required

This section describes the cleaning procedures that should be carried out not regularly but when required.

8-3-1. Draining lubricating oil

8-3-2. Cleaning the eye guard

8-3-3. Lubrication

Lubricate the machine head when required while referring to "3-20. Lubrication".

8-3-4. Draining water

1. When the oiler (1) has filled with oil, turn the oiler (1) to
remove it, and drain the oil.
2. After draining the oil, return the oiler (1) to its original
position.
NOTE:
Dispose of waste oil correctly in accordance with local
regulations.
If any of the oil spills onto the floor by mistake, wipe it all
up carefully.
0458B
Wipe the eye guard clean with a soft cloth.
NOTE:
Do not use solvents such as kerosene or thinner to
clean the eye guard. They may cause discoloration or
deterioration of the eye guard.
0459B
1. Tilt back the machine head.
2. Water may collect in the bed base (1) depending on the
condition of the air coming from the compressor, so drain
this water if necessary.
NOTE:
If water collects in the bed base (1), carry out the
inspections in "8-1-2. Checking the air filter". If water
still continues to collect, there may be a problem with
the air cylinder, so it is recommended that you install an
automatic drain (commercially-available).
0460B
RH-9820
8. CLEANING AND INSPECTION
70