Changing The Device Temperature Polling Interval; Displaying Fastiron Ls Cpu Usage - Brocade Communications Systems LS-STK Installation Manual

5

Displaying FastIron LS CPU usage

FastIron# temperature warning 47
Syntax: temperature warning <value>
The <value> can be 0 – 125.
For devices in an IronStack
To change the temperature warning level for a device in an IronStack, enter a command similar to
the following:
FLS624 device# temperature warning 2 82
Syntax: temperature warning <unit-id> <value>
Changing the temperature shutdown level
To change the temperature at which the device sends a warning, enter a command similar to the
following:
FastIron# temperature shutdown 47
Syntax: temperature shutdown <value>
The <value> can be 0 – 125.
For devices in an IronStack
To change the temperature shutdown level for a device in an IronStack, enter a command similar to
the following:
FLS624 device# temperature shutdown 2 90
Syntax: temperature shutdown <unit-id> <value>

Changing the device temperature polling interval

The software reads the temperature sensor and polls other hardware sensors according to the
value set for the device poll time, which is 60 seconds by default. You can change the device poll
time using the CLI.
To change the device poll time for standalone devices or for devices in an IronStack, enter a
command similar to the following at the global CONFIG level:
FastIron(config)# chassis poll-time 200
Syntax: chassis poll-time <seconds>
Displaying FastIron LS CPU usage
You can display the amount of CPU use by entering the show cpu command at any level of the CLI:
FLS648 Switch# show cpu
31 percent busy, from 3248 sec ago
1
5
60
300 sec avg:
52
DRAFT: BROCADE CONFIDENTIAL
sec avg: 31 percent busy
sec avg: 31 percent busy
sec avg: 31 percent busy
31 percent busy
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
53-1002187-01