Brocade Communications Systems LS-STK Installation Manual page 13

•
For information about the type of fiber optic modules supported, see
page 7.
FastIron LS and LS-STK 10/100/1000BASE-T ports
FLS and FLS-STK devicees contain 24 or 48 ports that operate at 10 Mbps or 100 Mbps, half or full
duplex, or at 1000 Mbps, full duplex. Because all ports on these devicees support automatic
MDI/MDI-X operation, you can use straight-through cables for all network connections to PCs or
servers, or to other devicees or hubs. (Refer to
MDIX cable for device-to-device connections.
Each of these ports support auto-negotiation, so the optimum transmission mode (half or full
duplex), and data rate (10, 100, or 1000 Mbps) can be selected automatically. If a device
connected to one of these ports does not support auto-negotiation, the communication mode of
that port can be configured manually.
Network interfaces
Table 1
TABLE 1
Interface
1000Base-BX-D
1000Base-BX-U
1000Base-LHA
1000Base-LHB
1000Base-LX
1000Base-SX
1000Base-SX2
1000Base-T
100Base-BX
100Base-FX
10GBase-CX4
10GBase-CX4 (XFP)
10GBase-ER
10GBase-LR
10GBase-LRM
10GBase-SR
10GBase-ZR
10GBase-ZRD
1310-MMF 10GbE
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
53-1002187-01
DRAFT: BROCADE CONFIDENTIAL
Optional 10 Gbps uplink modules (not available for FastIron LS 648-STK models)
describes the network interfaces supported on FastIron LS devices.
Supported network interfaces
Show media description
M-GBXD
M-GBXU
M-LHA
M-LHB
M-LX
M-SX
M-SX2
C
M-FBX
M-FX
XG-ER
XG-ER
XG-ER
XG-LR
XG-LRM
XG-SR
XG-ZR
XG-ZRD
1310-NM
Hardware features
"Fiber optic modules"
"Pinouts and signaling" on page 63.) It is best to use
1
on
3