Desktop Installation; Rack Mount Installation - Brocade Communications Systems LS-STK Installation Manual

2
Preparing the installation site

Desktop installation

FIGURE 13
1. Attach the four adhesive feet to the bottom of the first device.
2. Set the device on a flat desktop, table, or shelf near an AC power source. Make sure that
3. If you are installing a single device, go to
4. If you are installing multiple devicees, attach the adhesive feet to each device. Place each
5. If you are also installing a redundant power supply, place it close to the device.

Rack mount installation

NOTE
You need a #2 Phillips screwdriver for installation.
Before mounting the device in a rack, pay particular attention to the following factors:
•
•
•
•
Follow the steps below to mount devices in rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting
2. Attach the mounting brackets to the sides of the device as illustrated in
14
DRAFT: BROCADE CONFIDENTIAL
Attaching the adhesive feet
adequate ventilation is provided for the system – a 3 inch clearance is recommended on each
side.
device squarely on top of the one below, in any order.
Temperature: Since the temperature inside a rack assembly may be higher than the ambient
room temperature, make sure the rack-environment temperature is within the specified
operating temperature range. (Refer to
Mechanical loading: Do not place any equipment on top of a rack-mounted unit.
Circuit overloading: Be sure that the supply circuit to the rack assembly is not overloaded.
Grounding: Rack-mounted equipment should be properly grounded. Particular attention should
be given to supply connections other than direct connections to the mains.
brackets and mounting screws.
"Powering on the system"
"Operating environment"
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
on page 26.
on page 60.)
Figure 14.
53-1002187-01