Brocade Communications Systems LS-STK Installation Manual page 44

Upgrading hardware
FIGURE 31
11. Install the CX4 module in the slot in the rear panel, if necessary.
12. Replace the cover as follows:
13. If applicable, re-attach the rack mounting ears.
14. Reinstall the device in its equipment rack, if applicable.
15. Re-insert any power cables to power on the device.
Your memory and stacking EEPROM upgrade is now complete. Refer to the FastIron Configuration
Guide for information about how to operate your device in an IronStack.
34
DRAFT: BROCADE CONFIDENTIAL
Replacing the memory DIMM
5
•
Hold the cover on each side at the center and align the front of the cover with the end of
the serial interface on the front panel, so that the cover extends slightly past the front
panel of the device.
•
Slide the cover backwards until it is fully flush with the top of the device and slides into
place.
•
Re-insert the cover screws.
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
1
2
3
4
53-1002187-01