Installing An Sfp Transceiver; Powering On The System - Brocade Communications Systems LS-STK Installation Manual

2

Installing an SFP transceiver

Installing an SFP transceiver
FIGURE 24
Follow the steps below to install an SFP transceiver.
1. Consider network and cabling requirements to select an appropriate SFP transceiver type.
2. Insert the transceiver with the optical connector facing outward and the slot connector facing
3. Slide the SFP transceiver into the slot until it clicks into place.
NOTE
SFP transceivers are hot-swappable. The device does not need to be powered off before installing
or removing a transceiver. However, always first disconnect the network cable before removing a
transceiver.
NOTE
SFP transceivers are not provided in the device package.

Powering on the system

After you complete the physical installation of the system, you can power on the system.
1. Remove the power cable from the shipping package.
2. Attach the AC power cable to the AC connector on the rear panel.
3. Insert the power cable plug into a 115V/120V outlet.
To turn the system off, simply unplug the power cable or cables.
26
DRAFT: BROCADE CONFIDENTIAL
Inserting an SFP transceiver into a slot
down. SFP transceivers are keyed so they can only be installed in one orientation.
NOTE
The socket should be installed near the equipment and should be easily accessible.
NOTE
If the outlet is not rated 115/120V, stop and get the appropriate cable for the outlet.
F L S
6 2 4
F a s tl
r o n L
S 6 2 4
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
53-1002187-01