Changing The Temperature Warning And Shutdown Levels - Brocade Communications Systems LS-STK Installation Manual

NOTE
This information reflects IC and board temperatures. It does not reflect ambient temperature.
Syntax: show chassis
Displaying Syslog messages for temperature
The software sends a Syslog message and an SNMP trap if the temperature crosses the warning or
shutdown thresholds. The following methods describe how to view the system log on the device. If
you have configured the device to use a Syslog server or SNMP trap receiver, see the
documentation for the server or receiver.
To display the system log, enter the show log command at any CLI level:
FLS648 Switch# show log
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 8 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Dynamic Log Buffer (50 entries):
at 0 days 0 hours 2 minutes 0 seconds, level alert
Temperature 48.0 C degrees, warning level 45.0 C degrees, shutdown level 55.0 C
degrees
at 0 days 0 hours 1 minutes 0 seconds, level alert
Temperature 50.0 C degrees, warning level 45.0 C degrees, shutdown level 55.0 C
degrees
Logs for devices in and IronStack are displayed globally for the entire stack.
Syntax: show log

Changing the temperature warning and shutdown levels

The default warning temperatures and the default shutdown temperatures for FLS devices are:
For the FLS624 and FLS624-STK:
For the FLS648 and FLS648-STK:
NOTE
These temperatures reflect the temperature of the board inside the device.
To change the temperature at which the device sends a warning, enter a command similar to the
following at the Privileged EXEC level of the CLI:
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
53-1002187-01
DRAFT: BROCADE CONFIDENTIAL
•
Warning temperature is 85 degrees C (exhaust side)
•
Shutdown temperature is 90 degrees C (exhaust side)
•
Warning temperature is 85 degrees C (exhaust side)
•
Shutdown temperature is 90 degrees C (exhaust side)
Managing FastIron LS temperature settings
5
51