Brocade Communications Systems LS-STK Installation Manual page 33

5. To connect additional RPS devices, first disconnect the original RPS device from the AC power
DANGER
Once the RPS device is disconnected from the AC power supply, the RPS device will no longer
provide redundant power until after the additional RPS devices are installed, the AC power is
reconnected, and the RPS device completes the self-test procedure.
6. Check the LEDs on the RPS device to ensure proper operation. The Power LED should light up.
1
2
3
NOTE
For International use, you may need to change the AC power cable. You must use a power cable that
has been approved for the receptacle type in your country.
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
53-1002187-01
DRAFT: BROCADE CONFIDENTIAL
supply, then follow steps 1, 2, 4 and 5.
If it does not light, see Chapter 6, "Troubleshooting"
1
3
2
RPS Input Port
AC Power Supply Number 1
RPS Unit
Installing a redundant power supply
for more information.
4 FLS Units
5 RPS Output Port
6 AC Power Supply Number 2
2
4
5
6
23