Brocade Communications Systems LS-STK Installation Manual page 41

6. Remove the EEPROM from the package and align the lead pins over the EEPROM socket
FIGURE 28
.
1
7.
CAUTION
Make sure you insert the EEPROM so that lead pin 1 goes into the correct hole as shown in the
appropriate illustrations. If you accidentally insert the EEPROM backwards, the device will not
work and may be damaged when you apply power.
CAUTION
Do not push too hard. If the EEPROM does not readily go into the socket, stop pushing and verify
that the lead pins are straightened and properly aligned over the holes. Straighten any crooked
pins, then try again.
Brocade FastIron LS and FastIron LS-STK Hardware Installation Guide
53-1002187-01
DRAFT: BROCADE CONFIDENTIAL
(socket U12 for FLS624 devices, socket U2 for FLS648 devices). Refer to
for the EEPROM socket and Memory DIMM locations on FLS devices.
The semicircular indentation on the EEPROM is located on the same end as pin 1.
Pin 1 on EEPROM
1 2
Pin 1 2 Semicircular indentation
Align the semicircular indentation on the EEPROM with the semicircular cut-out on the
EEPROM socket and gently push the EEPROM into the socket.
Upgrading hardware
Figure 29 on page 32
3
31