Using An Ac Power Supply; Mounting The Viewfinder And Adjusting Its Position - Panasonic AJ-SPX900e Operating Instructions Manual

5-1-2 Using an AC Power Supply

When using the Panasonic AJ-B75 AC adapter
1
Plug the AJ-B75 DC OUT connector into the camera-
recorder's external DC input socket.
AC Adapter
AJ-B75 (Optional)
2
Turn the AC adapter power ON.
3
Turn the camera-recorder power switch ON.
When using an external power supply other than the AC
adapter AJ-B75, check the DC IN socket pin information to
ensure correct polarity. If a +12V power supply is
accidentally connected to the GND terminal, this could
cause a fire or personal injury.
4
3
2
1
DC IN Socket
<Notes>
When both the battery pack and AC adapter are
connected, power is supplied from the AC adapter. The
battery can be removed or mounted while using the AC
adapter.
When using the AC adapter, make sure you turn ON the
AC adapter power before turning ON the camera-
recorder's power switch. If this sequence is reversed, the
camera-recorder may malfunction due to slow rising of
the AC adapter output voltage.
When connecting a battery to the DC IN socket, select
the battery type listed under EXT DC IN SELECT. Select
EXT DC IN SELECT from the <BATTERY/P2CARD>
screen on the MAIN OPERATION page. In this case,
however, the % display is disabled, even when using a
digital battery.
70
DC IN Socket
Pin No. Signal
1 GND
—
2, 3
4 +12V
5-2 Mounting the Viewfinder and
Adjusting its Position
Please refer to the viewfinder instruction manual.
Note: A slide rail is required to mount any viewfinder other than
models AJ-VF15B or AJ-VF20WB.
If you need to buy a slide rail, please contact the store where
you purchased the camera-recorder and tell them that the
slide rail is a "repair part".
Slide rail (VFC3995)
Screws (XBS3+8VZ)
Mounting the Slide Rail
1
Undo the upper two screws for AJ-VF15 or AJ-VF20W, and
remove the mounting unit.
Leave the screws attached to the mounting unit.
Mounting unit
Screws
2
Mount the slide rail, then tighten the two screws.
Slide rail