Using An Ac Power Supply - Panasonic AJ-SDX900E Operating Instructions Manual

CONTENTS
Chapter 5 Preparation
5-1-2

Using an AC power supply

When the AJ-B75 AC adapter made by
Panasonic is used
1
Connect the DC OUT connector on the AJ-B75 AC
adapter to the DC IN socket on the unit.
AC adapter
AJ-B75 (optional accessory)
2
Set the power of the AC adapter to ON.
3
Set the unit's power switch to ON.
When using an external power supply other than the AJ-
B75 AC adapter, check the pin signals of its external DC
input connector and use the polarities correctly.
4
3
2
1
External DC input socket
<Notes>
≥ Power from the AC adapter takes precedence when
both a battery pack and AC adapter have been
connected. It is also possible to attach/remove a
battery while the AC adapter is being used.
≥ When using the AC adapter, be absolutely sure to first
set the power of the AC adapter to ON and then set the
unit's power switch to ON.
If the power is turned on in the reverse sequence, the
output voltage of the AC adapter will rise gradually, and
the unit may malfunction as a result.
60
DC IN socket
Pin no. Signal
1 GND
2, 3 –
4 +12V
Attaching the viewfinder
5-2
and adjusting its position
The viewfinder's position can be adjusted in the front-back
and left-right directions so that what appears on its screen
inside can be seen most easily.
Attaching the viewfinder and adjusting its position
1
Connect the viewfinder's plug to the viewfinder connector.
Loosen the ring.
2
Loosen the viewfinder left-right position anchoring ring.
3
While pulling up the viewfinder stopper, attach the
viewfinder by sliding it in the direction of the arrow.
Viewfinder stopper
Adjusting the viewfinder's left-right position
1
Loosen the viewfinder left-right position anchoring ring.
2
Slide the viewfinder to the left or right, and adjust it to a
position that allows easy viewing.
3
Tighten the viewfinder left-right position anchoring ring.
Viewfinder left-right
position anchoring ring
Tighten the ring.