Panasonic AJ-SPX900e Operating Instructions Manual page 97

5. P2 Card Fully Recorded
Display window All 7 bar indicators for remaining MEDIA capacity
indication start blinking.
Continues to light up until an operation is
WARNING lamp
performed.
Continues to blink 4 times per second until an
Tally lamp
operation is performed.
Viewfinder The END indicator blinks.
Continues
Warning tone
performed.
Warning
The P2 cards are recorded to maximum capacity.
description
Recording/
The recording stops.
playback operation
Delete the clips in the P2 card or insert a new P2
Countermeasures
card.
6. Recording Error
"00:00:00:11" appears in the time code display
Display window field. Even after recording is stopped, this display
indication continues to blink until the next operation is
performed.
Blinks 4 times per second while recording
WARNING lamp
continues.
Blinks 4 times per second while recording
Tally lamp
continues.
Viewfinder The REC WARNING indicator lights up.
Beeps 4 times per second while recording
Warning tone
continues.
Warning This indicates a failure either in the P2 card
description recording or the recording circuit.
Recording/
Recording stops.
playback operation
Restart recording. Or, turn the power OFF and
Countermeasures
turn it ON again, before starting recording.
to beep until an operation
7. Low Wireless Signal Reception
Display window
No display.
indication
Blinks 4 times per second. (During pause and
WARNING lamp
recording)
Blinks 4 times per second while recording
Tally lamp
continues.
The WIRELESS RF indicator lights up while
Viewfinder
recording continues.
is
Beeps 4 times per second while recording
Warning tone
continues.
Warning This error indicates poor wireless audio reception
description conditions.
Recording/ Continues to operate without receiving the
playback operation wireless microphone signal.
Check the microphone power supply and the
Countermeasures
reception status of the wireless receiver.
8. 1394 (when AJ-YAD800G is attached)
Display window The 1394 E-
indication lights up.
Blinks 4 times per second while the WARNING
WARNING lamp
lamp recording is continuing.
Blinks 4 times per second while the TALLY LAMP
WARNING lamp
recording is continuing.
In the case of Error Code 92, "1394 INITIAL
ERROR" indicator lights up (during pause and
recording)
Viewfinder
For Error Codes other than Error Code 92, or if
REC SIGNAL is set to "1394", no error is
displayed in the viewfinder.
Beeps 4 times per second while ALARM
Warning tone
recording is continuing.
Warning This indicates a failure of the DVCPRO/DV
description connector.
Recording/ The operation continues, but input signals to the
playback operation DVCPRO/DV connector are abnormal.
Check the connection between the IEEE1394
cable and the DVCPRO/DV connector, settings of
any external device and menus, and the turn on
the power again.
Countermeasures
If the warning indication is still illuminated,
confirm the "Error Codes" in the IEEE1394
interface board instruction manual, and consult
your nearest service center.
indicator in the display window
97
7