Panasonic AJ-SPX900e Operating Instructions Manual page 68

When using a BP-90 type battery pack
1
Remove the battery holder.
2
Attaching the battery case to the camera-recorder.
Connect the cable on the camera-recorder to the cable
on the battery case (BP-90 type).
Using a screwdriver, secure the battery case (BP-90
type) to the camera-recorder.
Open the cover and lift the rubber cap so that the screw
tightening hole is visible. Tighten the screws to secure
the battery case to the camera-recorder. Be sure to fully
tighten the screws.
<Notes>
Do not use excess force when lifting the rubber caps
forcibly.
Take special care not to pinch the cable.
Connect
68
Battery holder
Battery Case
(For BP-90 type)
3
Connect the battery pack plug to the socket inside the
battery case, and insert the battery pack into the case.
Label
surface
<Note>
Make sure you turn OFF the camera-recorder power before
connecting or disconnecting the plug.
4
Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/P2CARD>
screen on the MAIN OPERATION page.
Please refer to [8-6-2 BATTERY SETTING1] for more
information.