When Using Audio Devices; Connection Between The Usb 2.0 Port Of; The Aj-Spx900E And A Pc - Panasonic AJ-SPX900e Operating Instructions Manual

When Using the Unislot Wireless Receiver
1
Remove the cover to insert the wireless receiver and
secure it with the screws.
2
Set the AUDIO IN switch to [W.L.] depending on the audio
channel to be recorded.

5-4-3 When Using Audio Devices

1
Connect the audio device to the AUDIO IN jack with the
XLR cable.
2
Set the AUDIO IN switch to [REAR] for the channel to which
the XLR cable is connected.
3
Set the LINE/MIC/+48V selector switch on the rear panel to
[LINE].
AUDIO IN Switch
76
LINE/MIC/+48V
Selector Switch
AUDIO IN Jack
5-5 Connection between the USB 2.0
port of the AJ-SPX900E and a PC
By connecting the AJ-SPX900Ewith an external PC using USB
2.0, the P2 card connected to the AJ-SPX900E can be used as
a mass storage device.
Procedures for establishing a connection with a PC
1
Connect the USB cable to the USB 2.0 port.
<Notes>
The USB 2.0 cable is not included with AJ-SPX900E.
Please use a commercially available USB 2.0 cable
(shield with a ferrite core).
The length of the USB cable shall be not exceed 3
meters. Using a USB cable whose length is greater than
3 meters might result in erroneous operations.
2
Open the <SYSTEM MODE> screen on the SYSTEM
SETTING page from the menu, and set USB to ON.
When you establish the USB connection for the first time,
install the accessory P2 software for AJ-SPX900E on the
PC. Refer to the Installation Manual for the details.
USB 2.0
port