Camera Setting; Vf Display - Panasonic AJ-SPX900e Operating Instructions Manual

8-3-12 CAMERA SETTING

Items/ Adjustable
Data Saved Range
DETAIL ON Set the DTL (H, V) to ON or OFF.
OFF
S C U F E
2D LPF ON ON/OFF switching for the two-dimensional
OFF LPF that reduces cross-color.
S C U F E
HIGH COLOR ON ON/OFF switching for the HIGH COLOR
OFF mode, which enhances the color dynamic
range.
S C U F E
GAMMA ON Set the gamma circuit to ON or OFF.
OFF
S C U F E
TEST SAW ON Switch the test signal ON or OFF.
OFF
S C U F E
FLARE ON Set the flare correction to ON or OFF.
OFF
S C U F E
H-F COMPE. ON ON/OFF switching for the H-F COMPE
mode, which enhances the DTL in the high-
OFF
frequency range.
S C U F E
ZEBRA Pattern Display
Video Level
ON
109%
ZEBRA 2
DETECT
ZEBRA 1
DETECT
0%
<Note>
All items in CAMERA SETTING are setting targets of the item
PAINT MENU SW( ) R/W in the <SD CARD R/W SELECT>
screen.
Remarks
ZEBRA 2
OFF SPOT
8-4 VF

8-4-1 VF DISPLAY

Items/ Adjustable
Data Saved Range
DISP NORMAL NORMAL: Display status constantly.
CONDITION HOLD HOLD:
– C U F E
DISP MODE 1 Set the DISP MODE.
2 Switch the camera's Warning/Message
indication. Please refer to [4-7-4 Display
3
Modes and Setting Changes/adjustment
Result Messages] for more information.
– C U F E
VF OUT Y Select the VF output.
Y:
NAM
NAM: Output signal with the highest level
R
G
R:
B
G:
B:
– C U F E
VF DTL 0 Select the VF DTL.
Additionally enhance the DTL for the VF
:
3
signal. 0 setting is the same DTL as the
:
primary scan lines.
– C U F E
5
ZEBRA1 0% Set the ZEBRA1 detection level (IRE value).
DETECT :
70%
:
– C U F E 109%
ZEBRA2 0% Set the ZEBRA2 detection level (IRE value).
DETECT :
85%
:
– C U F E 109%
ZEBRA2 ON Set the ZEBRA2 to ON, OFF, or SPOT.
SPOT
OFF
– C U F E
LOW LIGHT LVL OFF Set the camera incoming light volume at
which to display LOW LIGNT.
10%
15%
20%
25%
30%
– C U F E 35%
ECU MENU ON Set the menu display on the VF to ON or
OFF when the ECU is connected.
DISP. OFF
– C U F E
50M ON Set the 50M recording indication to ON or
INDICATOR OFF OFF.
– C U F E
MARKER/CHAR 50% Adjust the brightness of markers and
LVL 60% characters displayed on the VF.
70%
80%
90%
100%
– C U F E
The ____ in the Adjustable Range column indicates the preset
mode.
Remarks
Display status only when the
MODE CHECK switch is pressed.
Brightness signal
among R, G, and B signals.
Rch signal
Gch signal
Bch signal
109
8