Using An Ac Power Supply - Panasonic AG-HPX500P Operating Instructions Manual

When using a V-mount type battery
pack
Mount the V-mount adapter plate. Insert the plate and
slide it in the direction of the arrow.
3
Setting the battery type.
• Select the battery type listed under BATTERY
SELECT. Select the menu option BATTERY
SELECT from the setting menu BATTERY
SETUP screen.
• When using a battery not listed under
BATTERY SELECT:
If it is a NiCD battery, select "NiCd14(14V)"
depending on the battery voltage. Set
the other items according to the battery
properties. If it is not a NiCd battery, select
TYPE A or TYPE B and set the other items
according to the battery properties. Please
refer to [BATTERY SET UP] for more
information.
<Note>
For information about the V-mount adapter plate,
please contact the store where you purchased
the camera-recorder.
82
Power Supply

Using an AC Power Supply

1
Plug the DC OUT connector into the
camera-recorder's external DC input
socket.
DC IN Socket
AC Adapter
2
Turn the AC adapter power ON.
(If the AC adapter is equipped with a power
switch)
3
Turn the camera-recorder power switch
ON.
• At power-on, a rush current occurs. Therefore,
use of an external AC power adaptor that assures
the power consumption twice as large as the
total amount of all the devices connected to the
unit. Also, use a DC cable of 10 A or more.
• When using an external power supply other
than the AC adapter, check the DC IN socket pin
information to ensure correct polarity. If a +12 V
power supply is accidentally connected to the
GND terminal, this could cause a fire or personal
injury.
4
1
2
3
DC IN Socket
Pin No. Signal
1
GND
-
2, 3
+12V
4