Handling Data; Handling Sd Memory Cards; Formatting, Writing And Reading; An Sd Memory Card - Panasonic AJ-SPX900e Operating Instructions Manual

4-10 Handling data

Setting Data Using an SD memory card
An SD memory card (optional accessory) can be used as a
setup card that stores up to eight files of settings menu
specifications.
This data allows you to quickly reproduce an optimum state.
Regarding SD memory cards, please see <Cautions in using SD
memory cards> (page 18).

4-10-1 Handling SD memory cards

An SD memory card may be inserted or removed, either before
or after the power is turned on.
To insert an SD memory card
Open the lid of the switch cover, and insert an SD memory card
(optional accessory) into the SD memory card slot with the notch
upward. Close the lid.
<Note>
An SD memory card must be inserted with the right side facing
the slot. If the card is hard to insert, it may be reversed or upside
down. Do not force it into the slot. Check the card before re-
inserting it.
To remove the SD memory card
Open the lid of the switch cover, and ensure that the BUSY lamp
is not illuminated. Then, further depress the SD memory card
towards the main unit. This releases the SD memory card from
the insertion slot. Take hold of the SD memory card and remove
it. Close the lid.
SD memory cards must not be used or stored in an
environment where they may be
Exposed to high temperatures/humidities;
Exposed to water droplets; or
Electrically charged.
For storage, the SD memory card must be kept inserted into the
AJ-SPX900E with the lid closed.
4-10-2 Formatting, Writing and Reading an
SD memory card
To format an SD memory card, write settings data or read data
on an SD memory card, navigate the menu to the <SD CARD
READ/ WRITE> screen from the FILE page.
For an SD memory card formatted with a device that does not
support SD standards, the message "FORMAT ERROR"
appears at the upper right of the screen. In this case, reformat
the card as follows. Note that the indication "FORMAT ERROR"
does not disappear if the SD memory card is replaced with this
menu page open. When the SD memory card is replaced,
perform TITLE READ.
<Note>
It is not possible to read from or write to an SD memory card
during INTERVAL REC mode operation by operating this menu.
Perform the operation after stopping interval recording.
To format an SD memory card
<Note>
SD memory cards may be formatted via the thumbnail screen.
For more information, see [6-15 Formatting SD memory cards].
1
Navigate the menu to the <SD CARD READ/WRITE>
screen.
2
Turn the JOG dial button to move the cursor to the menu
option CARD CONFIG.
3
Press the JOG dial button to display the following message:
4
59