Chapter 6 Unpack The Router; Tools Required; Unpack The Router; Figure 20: Unpack The Router - Juniper M10 Hardware Manual

Chapter 6

Unpack the Router

Tools Required

Unpack the Router
This chapter explains how to unpack the router and verify the parts received. Before
beginning, prepare the installation site as described in "Prepare for Router Installation"
on page 37 and review the safety information in "Safety and Regulatory Compliance
Information" on page 129, especially "General Safety Guidelines and Warnings" on page 131
and "Installation Safety Guidelines and Warnings" on page 146. This chapter discusses the
following topics:
•
Tools Required on page 55
•
Unpack the Router on page 55
•
Choose Front or Center Mounting on page 57
To unpack the router and prepare for installation, you need the following tools:
•
Utility knife for cutting the sealing tape on the shipping carton
•
Phillips (+) screwdriver, to move the mounting brackets and install the support shelf
if front-mounting the router
The router is shipped in a cardboard carton, held in place with foam packing material.
The crate also contains an accessory box, the front-mounting shelf, and the M5 and M10
Internet Router Installation Quick Start poster.
The router is maximally protected inside the shipping carton. Do not unpack
it until you are ready to begin installation.
To unpack the router, perform these steps:
1. Move the shipping carton to a staging area as close to the installation site as possible.
Unpack the Router
55