Maintain The Routing Engine - Juniper M10 Hardware Manual

Maintain the Routing Engine

The Routing Engine installs into a slot in the Forwarding Engine Board (FEB) at the
rear of the chassis, as shown in Figure 3. To maintain the Routing Engines, issue the
CLI show chassis routing-engine command on a regular basis to check the status of the
Routing Engine:
For further description of the output from the command, see the JUNOS Internet Software
Operational Mode Command Reference: Protocols, Class of Service, Chassis, and Management.
•
Verify that the air flow in and out of cooling system components is not obstructed.
user@host> show chassis routing-engine
Routing Engine status:
Temperature
DRAM
Memory utilization
CPU utilization:
User
Background
Kernel
Interrupt
Idle
Model
Serial ID
Start time
Uptime
Load averages:

Maintain the Routing Engine

35 degrees C / 95 degrees F
768 MB
16 percent
0 percent
0 percent
0 percent
0 percent
100 percent
RE-2.0
f1000004f91d2901
2003-05-01 15:07:12 PDT
3 days, 9 hours, 4 minutes, 5 seconds
1 minute 5 minute
0.04 0.01
Maintain Hardware Components
15 minute
0.00
79