Connect The Router And Perform Initial Configuration; Tools And Parts Required; Connect The Router To Management Devices - Juniper M10 Hardware Manual

Chapter 8

Connect the Router and Perform Initial Configuration

Tools and Parts Required

Connect the Router to Management Devices

After installing the router into the rack as described in "Initial Installation" on page 35,
complete the installation by connecting management and alarm devices, PICs, and power
cables. This chapter has the following sections:
•
Tools and Parts Required on page 61
•
Connect the Router to Management Devices on page 61
•
Connect PIC Cables on page 63
•
Provide Power to the Router on page 65
•
Configure the JUNOS Internet Software on page 69
To connect the router to management devices and PICs and to power on the router, you
need the following tools and parts:
•
Phillips (+) screwdrivers, numbers 1 and 2
•
Flat-blade (-) screwdrivers, 2.5 mm and 3 mm
•
Electrostatic damage (ESD) grounding wrist strap
After you have installed the router into the rack, attach one or more external devices to
the ports on the craft interface that connect to the Routing Engine for management and
service operations (see Figure 21). For specifications for the cable accepted by the Routing
Engine management ports, see "Cable Specifications for Routing Engine Management
Interfaces" on page 52.
Connect the Router and Perform Initial Configuration
61