Craft Interface; Figure 6: Routing Engine; Figure 7: Craft Interface - Juniper M10 Hardware Manual

Craft Interface

Figure 6: Routing Engine

Routing Engine 333
Extractor clip
LED
PC card slot

Craft Interface

The craft interface provides status and troubleshooting information at a glance and has
buttons for deactivating alarms and preparing FPCs for removal. The L-shaped craft interface
is located along the left and bottom edges of the front of the chassis, as shown in Figure 1
and Figure 2. It includes the elements shown in Figure 7. (The LEDs for the power supplies
are located on the power supply faceplate, rather than on the craft interface. For more
information, see "Power Supply LEDs and Self-test Button" on page 19.)

Figure 7: Craft Interface

Lamp test button
Link status LED
Routing Engine
ports
14
M5 and M10 Internet Routers Hardware Guide
For specific information about Routing Engine components (for example, the
capacity of the hard drive), issue the show chassis routing-engine command.
Extractor clip
R
Red alarm LED
Yellow alarm LED
Activity status LED
PIC0/3
PIC1/3
Routing Engine 600
Extractor clip
PC card slot
LED
PIC0/2 PIC0/1
PIC1/1
PIC1/2
PIC online/offline buttons
Extractor clip
PIC0/0
PIC1/0