Table of Contents
Advertisement
Replace Routing Engine Components
1.
2.
3.
4.
Figure 46: Serial Port Connector
120
M5 and M10 Internet Routers Hardware Guide
If a cable is already installed in the CONSOLE or AUX/MODEM port, perform the
following steps:
a.
Turn off the power to the console or auxiliary device.
b.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
flat-blade screwdriver if necessary.
c.
Pull the cable connector straight out of the port.
d.
Disconnect the cable from the console or auxiliary device.
Plug the female end of the replacement serial cable into the appropriate CONSOLE or
AUX/MODEM port. Figure 44 shows the external device ports on the craft interface.
Tighten the screws on the connector, using a 2.5-mm flat-blade screwdriver if necessary.
Power on the auxiliary or console device.
Advertisement
Table of Contents
Troubleshooting
