Printer Button And Lights - Avery Dennison Label Printer User Manual

Print and Peel Labels
To print and peel labels, you must activate the peel
setting after loading the labels into the printer. Move
the Peel Lever to its peeling position (DOWN) while a
label is sticking out of the printer. This traps the label
and liner (the sheet that the label comes off) between
the peel roller and a tensioned idle roller and pulls the
label and liner over a strip edge of plastic that separates
the label from the liner for easy removal. Printing with
this setting is always one label at a time and the unit
will wait for you to press the Advance button before
printing the next label, even if you sent multiple labels
to the printer.

Printer Button and Lights

The Avery Personal Label Printer has a button/light indicator on the front of the machine
®
which is the Advance button and a Status Light Indicator in the Top Door for additional
messages during printing.
• The Advance button light will glow solid GREEN when the Peel Lever is down and the
printer is in the peel setting. Pressing the button while it is solid GREEN will print and
advance to the next label.
• Pressing the Advance button, at any time, will form feed the
roll to the next label without printing.
• The Status Light Indicator located in the Top Door will
glow solid GREEN when the unit is powered and during
normal operation. It will flash GREEN when the label is
advancing through the printer.
• The Status Light Indicator in the Top Door will flash RED
if any jam or other critical error occurs during normal
operation.
• The Status Light Indicator in the Top Door will flash
AMBER if the unit recognizes the Avery
Printer roll but did not correctly form feed to the next label.
The Avery ® Personal Label Printer was designed to work best
with authentic Avery Dennison labels. (Refer to the Troubleshooting section for more infor-
mation)
Advance Button
Personal Label
®
®
Avery Personal Label Printer
Status Light
Indicator
13