Xcommand Experimental Call Attendedtransfer; Xcommand Experimental Call Unattendedtransfer; Xcommand Experimental Camera Directircontrol; Xcommand Experimental Setlowlevel - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

xCommand Experimental VideoIndicator

NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Parameters:
VideoSourceId(r): <0..2147483647>
Show(r): <On/Off>
PositionX(r): <0..10000>
PositionY(r): <0..10000>
Example:
xCommand Experimental VideoIndicator VideoSourceId:0 Show:Off PositionX:0
PositionY:0
*r VideoIndicatorResult (status=OK):
** end

xCommand Experimental Camera DirectIRControl

NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Parameters:
CameraId(r): <1..7>
OnOff(r): <On/Off>
Example:
xCommand Experimental Camera DirectIRControl CameraId:1 OnOff:Off
*r CameraDirectIRControlResult (status=OK):
** end

xCommand Experimental SetLowLevel

NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
ADMIN
Requires user role:
Parameters:
Mode(r): <On/Off>
Example:
xCommand Experimental SetLowLevel Mode:Off
*r SetLowLevelResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

xCommand Experimental Call UnattendedTransfer

xCommand Experimental Call AttendedTransfer

xCommand Experimental UserInput

110
xCommand xCommand
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Parameters:
CallId(r): <0..65534>
Number(r): <S: 0, 255>
Example:
xCommand Experimental Call UnattendedTransfer CallId:321 Number:12345678
*r CallUnattendedTransferlResult (status=OK):
** end
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
Requires user role: ADMIN
Parameters:
FirstCallId(r): <0..65534>
SecondCallId(r): <0..65534>
Example:
xCommand Experimental Call AttendedTransfer FirstCallId:321 SecondCallId:322
*r CallAttendedTransferlResult (status=OK):
** end
NOTE: This Experimental command can be used 'as is' and will not be further documented. The
Experimental settings WILL change.
ADMIN
Requires user role:
Parameters:
CallId(r): <0..65534>
Device(r): <Mouse/NavKey>
Button(r): <0..65534>
Action: <Click/Click2/Click3/None/Press/Release>
PositionX: <0..10000>
PositionY: <0..10000>
Example:
xCommand Experimental UserInput CallId:0 Device:NavKey Button:0
*r UserInputResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com