Solaris Os Issues - Fujitsu SPARC Enterprise T5120 Product Notes

Solaris OS Issues

TABLE A-4
Fixed Solaris OS Issues
TABLE A-4
CR Description
6243759 The Solaris prtdiag command displays device
paths incorrectly for e1000g driver devices.
(6479347)
6527622 After the OS panic, the server may display the
following message and stop at the ok prompt.
WARNING: promif_ldom_setprop: ds
response timeout
WARNING: unable to store boot command
for use on reboot
6536482 Currently, cpummem does not diagnose the
fbr/fbu errors.
6552999 Performing a Control-C while the prtdiag -v
command is running causes blank
environmental data fields when run again.
The missing output is persistent until the picld
SMF service is restarted.
116 SPARC Enterprise T5120 and T5220 Servers Product Notes • April 2010
lists the Solaris OS issues that have been fixed.
Workaround
Note - Fixed in the Solaris 10 5/08 OS (and
later) and in the Solaris 10 8/07 OS with patch
ID 127127-11 or later installed.
Force load all instances of the e1000g driver
and then restart the picld daemon as follows:
# devfsadm -i e1000g
# svcadm restart svc:/system/picl
Another workaround is to use the -r option
when booting or rebooting the system.
You can also upgrade the OS or install the patch
to avoid encountering this issue.
Note - Fixed in Solaris patch ID 127111-05 or
later.
Set auto-boot?=true or use the boot
command to start the server manually.
Note - Fixed in Solaris patch ID 127127-11 or
later.
Note - Fixed in the Solaris 10 10/08 OS or by
installing patch ID 13094-01 or later.
If the environmental data is missing from the
prtdiag output, restart the picld SMF service
in the control domain with the following
command:
# svcadm restart picl
You can also upgrade the OS or install the patch
to avoid encountering this issue.