Fujitsu SPARC Enterprise T5120 Product Notes page 48

Firmware, ILOM, POST, and SP Issues (Continued)
TABLE 3-3
CR Description
6739633 When the host is off, any prepare_to_remove
operation for the component selected in the
ILOM Web interface (System Information tab ->
Components tab) may cause the radio button of
the component to disappear.
In the "Ready to Remove Status" column,
"NotReady" changes to "Ready (No Power)" for
the component, but "Return to Service"
cannot be performed for the component because
the radio button is no longer displayed.
6738510 Specifying the -t option in certain commands
(create, delete, exit, load, reset, set,
start, stop, version) may cause a forced
logout from the ILOM CLI.
6739602 If the logdetail property in
/SP/clients/activedirectory is set to a
value other than "none," the following
authentication error message may be displayed
even if ActiveDirectory is set to disabled (state =
disabled):
sc> ActDir | critical: (ActDir)
authentication status: auth-ERROR
6837115 On the ILOM Web interface, when you change
the "Alert Management" settings from "Level:
minor" and "Type: IPMI PET" to "Type: SNMP
Trap" the level setting changes to "disable." The
level must be set again.
6765542 While the external I/O expansion unit is being
powered on, when you power off/on the server,
the SNMP information of the external I/O
expansion unit may fail to be obtained.
It can be recovered by removal/insert of the
power cord of the external I/O expansion unit
and power-off/on of the server.
6881020 When you set /HOST bootfailrecovery to
powercycle, powercycle (host power-off/on)
fails to be executed.
36 SPARC Enterprise T5120 and T5220 Servers Product Notes • April 2010
Workaround
Make the following setting from the CLI:
• set /SYS/(selected-component)
return_to_service_action=true
None.
If ActiveDirectory is set to disabled, ignore the
message.
None.
None.
None.
Set to poweroff, wait for the host power turns
off and then manually turn on the host power.