Fujitsu SPARC Enterprise T5120 Product Notes page 43

Firmware, ILOM, POST, and SP Issues (Continued)
TABLE 3-3
CR Description
6760139 ILOM firmware and OpenBoot PROM (OBP)
setting information may not be inherited during
motherboard replacement.
6762635 One of the following messages may be output
while a POST (self-diagnostics test) is in
progress, and POST processing may not be
completed.
Also, a transition to OpenBoot PROM (OBP)
may occur.
Message examples:
Fault Sensor VMEML_POK at /SYS/MB
deasserted
Fault Sensor VCORE_POK at /SYS/MB
deasserted
Fault Sensor VMEMR_POK at /SYS/MB
deasserted
6761778 The following error message may be displayed:
Message example:
picld[154]: [ID 276222 daemon.error]
PICL snmpplugin: sunPlatSensorClass 0
unsupported (row=388)
Workaround
If an ILOM firmware initialization has been
performed or any of the firmware settings have
been changed, follow the procedure below to
save the latest ILOM firmware setting
information. After replacing the motherboard,
set the saved setting information again.
(Procedure for saving ILOM firmware setting
information)
1) Log in to ILOM, execute the following
commands, and save the displayed results:
-> show /SP -level all -o table
-> show /SYS -o table
-> show /HOST -level all -o table
2) Log in to the ALOM CMT compatibility
shell, execute the following command, and
save the displayed results:
sc> showsc
(Recovery procedure)
Disconnect and then reconnect the power cable.
Ignore this message.
Chapter 3 Known Issues 31