Fujitsu SPARC Enterprise T5120 Product Notes page 131

Sparc enterprise servers
Hide thumbs Also See for SPARC Enterprise T5120:
Table of Contents

Advertisement

Fixed Solaris OS Issues (Continued)
TABLE A-4
CR
Description
6589612
The raidctl -l command continuously
outputs the following output:
# raidctl -l
Controller: 1
Disk: 0.0.0
Disk: 0.0.0
...
6592238
You might not be able to remove a RAID 1
volume after RAID 1 and RAID 0 volumes are
created.
When two volumes are created through the
onboard SAS controller (or any controller that
uses the mpt driver), the raidctl utility is
unable to delete one of the RAID volumes and
cannot list the correct disk information. When
this occurs, the following is the error message is
displayed:
# raidctl -l
Device record is invalid.
6594506
After certain hardware error events, it is possible
that Solaris PSH events are no longer
transported between the SP and the domain.
For examples, see
Transported (CR 6594506)" on page
6596503
The output of the Solaris prtpicl -v
command might show CPU cores or strands
with an operational status of enabled when the
cores or strands do not exist.
Volume:c1t0d0
Volume:c1t2d0
"PSH Events Are no Longer
Workaround
Note - Fixed in the Solaris 10 5/08 OS (and
later) and in the Solaris 10 8/07 OS with patch
ID 127127-11 or later installed.
Use the Control-C keyboard sequence to stop the
output.
You can also upgrade the OS or install the patch
to avoid encountering this issue.
Note - Fixed in the Solaris 10 5/08 OS (and
later) and in the Solaris 10 8/07 OS with patch
ID 127127-11 or later installed.
Update the OS to the latest version or install the
mandatory patches to avoid encountering this
issue in the future.
Note - Fixed in the Solaris 10 5/08 OS (and
later) and in the Solaris 10 8/07 OS with patch
ID 127127-11 or later installed.
"PSH Events Are no Longer Transported
See
124.
(CR 6594506)" on page
You can also upgrade the OS or install the patch
to avoid encountering this issue.
Note - Fixed in System Firmware 7.1.6.d or
later.
Instead, use the output from the prtdiag or
prtpicl -c cpu commands.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
124.
Appendix A
Fixed Issues
119

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sparc enterprise t5220

Table of Contents