Sparc Enterprise T2000 Correctable Memory Errors In Post Could Be Misleading (Cr 6479408); Erroneous Fault Messages Displayed After A Solaris Os Jumpstart Installation - Fujitsu SPARC Enterprise T2000 Product Notes

could automatically install an earlier version of the utility on your system. After
installing any of the Java ES software, determine whether an earlier version of the
Sun Explorer product has been installed on your system by typing the following:
# pkginfo -l SUNWexplo
If an earlier version exists, uninstall it and install version 5.7, or later.
SPARC Enterprise T2000 Correctable Memory Errors in POST
Could Be Misleading (CR 6479408)
POST error messages regarding unsupported memory configurations can be
misleading. In situations where memory rank 0 (zero) is fully populated, the
following message can be ignored safely.
ERROR: Using unsupported memory configuration
Erroneous Fault Messages Displayed After a Solaris OS
JumpStart Installation
If you perform a Solaris JumpStart™ installation of a SPARC Enterprise T2000
server, the server will display erroneous PSH fault messages at boot time. To correct
this situation, you must install the SPARC Enterprise T2000 mandatory patches and
make changes to the /etc/system file. In addition, you should also clear the PSH
and ALOM CMT fault logs to prevent the erroneous messages from being reported
again. The steps to do this are described in
JumpStart Installation" on page
Example of Erroneous Fault Messages at boot time:
SUNW-MSG-ID: SUN4-8000-0Y, TYPE: Fault, VER: 1, SEVERITY: Critical
EVENT-TIME: Fri Jan 27 22:17:36 GMT 2006
PLATFORM: SUNW,SPARC-Enterprise-T2000, CSN: -, HOSTNAME: xx
SOURCE: eft, REV: 1.13
EVENT-ID: d79b51d1-aca0-c786-aa50-c8f35ea0fba3
DESC: A problem was detected in the PCI-Express subsystem.
Refer to http://sun.com/msg/SUN4-8000-0Y for more information.
AUTO-RESPONSE: One or more device instances may be disabled
IMPACT: Loss of services provided by the device instances
associated with this fault
REC-ACTION: Schedule a repair procedure to replace the affected
device. Use fmdump -v -u EVENT_ID to identify the device or contact
support.
6 SPARC Enterprise T2000 Server Product Notes • May 2010
"To Configure the System After a
7.