For Dc Input Power Models, The Output From The Showpower -V Command May Differ Between /Sys/Ps0 And /Sys/Ps1 (Cr 6802433) - Fujitsu SPARC Enterprise T5120 Product Notes

For DC Input Power Models, the Output From the
showpower -v Command May Differ Between
/SYS/PS0 And /SYS/PS1 (CR 6802433)
This issue is resolved by updating the system firmware to 7.2.2.e or later.
For DC input power models, the INPUT limit value included in the output from the
showpower -v command may differ between /SYS/PS0 and /SYS/PS1. The
/SYS/PS1 value is correct.
[Example of showpower -v command execution]
sc> showpower -v
-----------------------------------------------------------------
Power Supplies:
-----------------------------------------------------------------
Supply Status
-----------------------------------------------------------------
/SYS/PS0 OK
/SYS/PS1 OK
-----------------------------------------------------------------
Total Power
-----------------------------------------------------------------
INPUT
Volt
Supply (V)
-----------------------------------------------------------------
/SYS/PS0 -48.0
/SYS/PS1 -48.0
sc>
(*) This is incorrect. The /SYS/PS0 value is correct.
Workaround: None. Ignore this issue because it is only a display error.
INPUT OUTPUT
Power Power
(W) (W)
172.8 123.8
153.6 133.3
326.4
INPUT INPUT
Current limit
(A) (A)
3.60 37.20
3.20 8.00(*)
OUTPUT OUTPUT
Volt Current
(V) (A)
11.9 10.40
11.9 11.20
Appendix A Fixed Issues
OUTPUT
limit
(A)
99.20
99.20
109