Fujitsu SPARC Enterprise T5120 Product Notes page 98

Fixed Firmware, ILOM, POST, and SP Issues (Continued)
TABLE A-3
CR Description
6598381 In rare circumstances, the PCIe interface unit
(PIU) might issue a spurious error interrupt.
For examples, see
6598381)" on page
6611700 When the OpenBoot PROM is set to input-
device=keyboard, you might see the
(6601900)
following warning message when the system
host is powered on or reset:
No keyboard support found
A U.S. keyboard will work properly.
International keyboards (French, German, and
so on) might behave as U.S. keyboards.
6602913 IPMI power off or power cycle operations might
fail.
6604305 During system initialization, memory might not
be detected, and the following error is reported:
ERROR: MB/CMP0/BR3/CH0/D0 must be
populated.
Rarely, the probing of DIMMs fails due to ILOM
simultaneously updating DIMM information.
When the DIMM probing fails, the host either
boots with a reduced memory configuration, or
fails to boot. This situation is not likely to
happen when the service processor (SP) is reset,
because the DIMMs are probed before ILOM
starts dynamic fruid updates. This issue is
most likely to occur when the host is being
repeatedly powered on and off without resetting
the SP.
6612687 Repeated attempts to show or set the serial port
properties of the host port might cause the
ILOM CLI to hang and become unresponsive.
86 SPARC Enterprise T5120 and T5220 Servers Product Notes • April 2010
"Spurious PIU Errors (CR
104.
Workaround
Note - Fixed in System Firmware 7.1.6.d or later.
These events are harmless and can be ignored.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
Note - Fixed in System Firmware 7.1.6.d or later.
Do not use USB keyboards. Instead, use a virtual
console by setting the input-device variable to
virtual-console.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
Note - Fixed in System Firmware 7.1.6.d or later.
Repeat the IPMI power off, or power-cycle
operation, or use one of the other available
interfaces to perform this operation.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
Note - Fixed in System Firmware 7.1.6.d or later.
Power off the host, reset the SP, and power on the
host.
You can also update the System Firmware to the
latest version to avoid encountering this issue.
Note - Fixed in System Firmware 7.0.9 or later.
Do not configure the host serial port properties
from the service processor. Instead, set the
properties from the Solaris OS.
If the ILOM CLI hangs, you must reset the system
by power cycling the AC power.