Hard drive
System configuration card
FIGURE 1-4
1.2.6
On/Standby Switch
Access to the On/Standby switch is by opening the front bezel. The On/Standby
switch controls only the power state of the server, it does not isolate the server from its
electrical power source.
The On/Standby switch is a momentary switch and has two operation modes:
Press and immediately release
■
Press and hold down for more than 4 seconds
■
The results of these actions are summarized in
Location of Front Panel Features (Sun Fire V240 Server)
Keyswitch
On/Standby switch
DVD-ROM drive
.
TABLE 1-3
Chapter 1 Introduction
1-9