3. Type:
ok setenv diag-level value
Where value is either min or max depending on the desired range of coverage.
4. Type:
ok setenv diag-trigger user-reset
5. Type:
ok setenv diag-trigger all-resets
Note – Status and error messages could be displayed in the console window. If
POST detects an error, it displays an error message describing the failure.
6.4.3
Controlling POST Diagnostics
You control POST diagnostics, and other aspects of the boot process by setting
OpenBoot configuration variables. Changes to OpenBoot configuration variables
generally take effect only after the system is restarted.
important and useful of these variables. You can find instructions for changing
OpenBoot configuration variables in
Variables" on page
6-6
Sun Fire V210 and V240 Servers Administration Guide • December 2005
Section 6.9, "OpenBoot Configuration
6-26.
lists the most
TABLE 6-2