Note – If you intend to remove a hard drive with Solaris running, follow the
instructions in
on page 2-11
1. Open the front bezel.
See
Section 2.2.2, "Opening the Front Bezel" on page
2. Check that the blue indicator LED is lit on the hard drive.
The blue LED comes on when the hard drive is ready to remove.
3. Slide the catch at the front of the hard drive to the right.
This releases the handle on the front of the hard drive.
4. Pull the handle and remove the hard drive from the server by sliding it out from
its bay.
2.5.2
Replacing a Hard Drive
Caution – The server and hard drives contain electronic parts that are extremely
sensitive to static electricity. Wear a grounded antistatic wrist strap when you carry
out this procedure.
FIGURE 2-4
2-8
Sun Fire V210 and V240 Servers Administration Guide • December 2005
Section 2.5.4, "Removing a SCSI Hard Drive With Solaris Running"
before performing the following steps.
Installing a Hard Drive (Sun Fire V210 Server)
2-2.