Table of Contents
Advertisement
4.
Lift the bay out of the system unit.
5.
The aperture in the chassis at the front of the drive bay
is obscured by a blanking plate. The blanking plate is
attached to the top of the chassis and must be removed
in order to install a drive in the 5.25" drive bay.
Open the drive bay door and identify the blanking
plate.
6.
Break the blanking plate out by bending it backwards
and returning it to the vertical several times.
7.
Remove the drive from its packaging. With the drive
there should be four screws and a signal cable. Some
drives may be supplied with additional items.
8.
If necessary configure the drive. Drives purchased
from an authorized supplier will be correctly
configured for installation in your computer.
For information on how these drives are configured
see the drive specific information following these
installation instructions.
9.
Identify the top and bottom of the drive.
10. Rest the drive, top down, on a suitable anti-static
surface.
11. With the drive bay upside-down place it over the
drive. Make sure that the bay and the drive are in the
same orientation.
Expanding the system
BLANKING PLATE
XEN OWNER'S HANDBOOK 5/17
Advertisement
Table of Contents
