Mitsubishi Electric Apricot XEN pentium Owner's Handbook Manual page 83

The illustration below shows the location of the sockets, and
identifies the two banks.
Installation
In order to install a memory upgrade you must:
BANK 0
1. Power the system down.
2. Take suitable anti-static precautions and remove the
system unit cover.
If you are unfamiliar with the recommended anti-static
precautions and/or the process of removing the
system unit cover refer to the appendices at the rear
of this manual.
The SIMM connectors are located beneath the 5.25"
drive bay. In order to install a memory upgrade you
must remove the 5.25" drive bay.
Expanding the system
BANK 1
XEN OWNER'S HANDBOOK 5/7