Table of Contents
Advertisement
UK plug wiring instructions
IMPORTANT Power
Cable Connections
This appliance is supplied with a mains lead that
has a non-removable moulded plug. If the socket
outlets are not suitable for the plug supplied with
this appliance, it should be cut off and an
appropriate three-pin plug fitted.
Note: The plug severed from the mains lead must
be destroyed, as a plug with the bared flexible
cord is hazardous if engaged in a live socket
outlet.
The following wiring information should be
employed when adding the replacement plug.
The wires in the mains lead are coloured in
accordance with the following code:
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows.
The wire which is coloured green-and-yellow
must be connected to the terminal in the plug
which is marked with the letter E, or by the earth
symbol
yellow.
Noise levels
German Acoustic Noise Regulation
Sound power level is less than 70 dB(A) according to DIN
45635 Part 19 (ISO 7779).
Die Deutsche Akoustische Lärm-Regulierung
Der Grad der Klangstärke ist weniger als 70 dB(A) je nach DIN
45635 Teil 19 (ISO 7779).
Safety and Regulatory Notices
Green and Yellow
Earth
Blue
Neutral
Brown
Live
or coloured green or green-and-
CLASS 1
LASER PRODUCT TO IEC 825
LASER KLASSE 1
PRODUKT NACH IEC 825
The wire which is coloured blue must be connected
to the terminal which is marked with the letter N or
coloured black. The wire which is coloured brown
must be connected to the terminal which is marked
with the letter L or coloured red.
Use a fuse approved by ASTA to BS1362, i.e.
carries the
mark.
ASA
Always replace the fuse cover, never use the plug
with the fuse cover omitted.
Replace with same colour fuse cover only.
Replacement fuse covers may be obtained from
your dealer.
WARNING -
THIS APPLIANCE MUST BE
EARTHED
This diagram
shows the wiring
inside the moulded
plug. Use it as a
guideline if you
need to re-fit a plug
of a similar type to
N
the mains lead.
The CD-ROM drive is
classified as a CLASS 1
LASER PRODUCT.
The CLASS 1 LASER
PRODUCT label is
located on the under
side of the system unit.
XEN OWNER'S HANDBOOK III
E
L
Advertisement
Table of Contents
