Table of Contents
Advertisement
Expanding the system
IDE drives are normally configured using jumpers on the drive.
Configuration details may vary from drive to drive. Authorized
drives are supplied with documentation describing how to
configure the drive.
If you are uncertain about configuring the drive, check with
your supplier.
Installing the drive
5/24 XEN OWNER'S HANDBOOK
1.
Having configured the drive, turn the drive bay upside-
down and rest it on a flat surface with the front of
the floppy drive towards you.
2.
Slide the hard disk drive you are installing into the bay
from the front, with the drive circuit board up, and
its connectors away from you.
Warning
If there is a drive in the bay already, be careful to ensure
that the new drive does not touch it.
Warning
It is possible to damage hard disk drives when attaching
them using side mounting holes. When installing hard disk
drives from an authorized supplier make sure that you
use the screws supplied with the drive.
Advertisement
Table of Contents
