Table of Contents
Advertisement
SETUP
Diskette Drive A and B
These two items indicate to the system the type of floppy drive
installed in each of the two drive bays. The options for each drive
are: None, 360KB 5.25", 1.2MB 5.25", 1.44MB 3.5" and 2.88MB 3.5".
Diskette Drive A is always a 1.44MB 3.5" drive, if a second
floppy drive is fitted it will normally be a 1.2MB 5.25" drive.
The other options are provided for compatibility reasons.
Video Setup
The Video Setup menu shows you the type of video controller
and amount of video RAM fitted to the motherboard, and allows
you to configure the video subsystem to suit your monitor.
The Video Controller and Video Memory items are displayed
for information only and are not editable.
Video Display
This option lets you choose between a number of monitor
types, or to select Custom.
The options alter the timings of video signals at the video
connector to suit a variety of different types of monitor, it is
important to ensure that you have made the correct selection.
The choices are:
Selection
SVGA
VGA/EVGA
4/8 XEN OWNER'S HANDBOOK
Monitors supported
Choose this if you are using an SVGA
monitor i.e. a monitor that supports
800x600
non-interlaced
1024x768 interlaced video modes, in
addition to standard VGA modes.
This option should be chosen for VGA
monitors, and for EVGA monitors to
run at normal refresh rates. EVGA
monitors support 800x600 and
1024x768 non-interlaced video, modes
in addition to standard VGA modes.
Some EVGA monitors may also support
the 1280x1024 resolution.
and
Advertisement
Table of Contents
